First of all, in the laboratory environment, it is necessary to select a good installation site. This is the prerequisite for the correct use of the air system in the compressors of the high and low temperature series test equipment. If the experimental environment of the test equipment is not planned beforehand, it is not known that such sloppy results will lead to difficulties in the maintenance of compressor malfunctions and poor quality of compressed air in the future.
1. Since the compressor has an air circulation system, if there is much air dust in the surrounding environment of the equipment, a filtering device must be added. At the same time, combustible gases and corrosive gases must not be contained in the air to avoid explosion or internal corrosion. On the whole, to ensure that the relative humidity of the air is low, the ash is often small and well ventilated.
2, the compression performance should not be subject to high temperatures, the ambient temperature is less than 30 °C is appropriate. If the temperature is too high, the output air volume of the compressor will be reduced.
3, equipment should be placed in a spacious place, narrow space is not conducive to the late maintenance and repair, especially the compressor's freezer radiator (condenser) should be regularly maintained and kept clean.
4. The voltage of the test chamber work site should be kept stable. On the contrary, the current will be too large or too small. Working under this condition for a long time will lead to compressor damage.
5, the test box should be built on a hard floor, the level of the foundation plane must be set before installation to avoid vibration caused by the compressor and cause noise.
High-low temperature test equipment in the test process, the correct operation and reasonable handling of failure, is conducive to the maintenance of the compressor and prolong life.
1. It is not appropriate to start the compressor frequently during the test. The interval between the start of the compressor is 15 minutes.
2. When the equipment is in commissioning operation, strictly inspect the compressor's running direction. When it is found that the reversal should be immediately shut down, cut off the power supply, and reverse any two of the three-phase lines before restarting it. Otherwise, the compressor will be damaged.
3. Test equipment During work, regular inspections of compressor safety valves and other protection systems ensure that they are sensitive and reliable.
PVC S Mat is made of eco friendly PVC material with Open PVC S Grid . The open S grids built a high-performance scraper and drainage matting. Dust is scrape by S grids ,water and moisture is drained by spaces between S grids. This kind of PVC Plastic floor mat can improve the safety and environment for your entrance areas and wet areas such as pool around,wet rooms. Having good effect of anti-slip , and good ability of mould proof.
Colors:Red,green,grey,black and so on.
Pvc S Mat,Pvc Non Slip Mat,Pvc Plastic Floor Mat,Pvc Loop Mat
Jiangyin Yining E-Commerce Co., Ltd , https://www.jsjyyining.com