Matters needing attention: 1. When the instrument has abnormal sound during use, check whether the instrument is uneven or the shaft is faulty. 2. When the deviation between the measured temperature of the instrument and the set temperature is greater than ± 3 ℃, the instrument will automatically alarm, press the temperature function key to eliminate the alarm for 30 minutes, and check the cause of the alarm. 3. When the shake bottle is damaged during the experiment, clean it in time to avoid the fermentation liquid corroding the shaker. 4. The shaker bottle should be placed symmetrically with the center of the shaker, not at random.
Standard operating procedures: 1. Turn on the main power switch on the right side, and power on the whole machine 2. Press the speed function key, then press the parameter modification / confirmation key, then press to increase to "3", and then press the speed function key In the fixed state, the set value of the speed is displayed, at the same time SV flashes, press the increase key or the decrease key to change the speed to the required value, and finally press the parameter modification / confirmation key to confirm. 3. Press the temperature function key, then press the parameter modification / confirmation key, then press the increase key to "3", and then press the temperature function key, the instrument enters the temperature parameter setting state, displays the temperature setting value, and SV flashes, Press the increase key or decrease key to change the temperature to the required value, and finally press the parameter modification / confirmation key to confirm. 4. After completing the above settings, press the start / pause key, and the instrument will start running according to the set program. 5. If it is necessary to temporarily suspend the instrument during the operation of the instrument, observe the experimental results, press the start pause button, the shaker will stop oscillating, and then press the start / pause button, the instrument will start shaking again. 6. After the experiment is completed, press and hold the power button on the control panel for 2 seconds to shut down the instrument, turn off the power switch on the right side of the instrument, and shut down the machine. 7. Check and clean the instrument and fill in the instrument usage record.
Sports Artificial Grass,Synthetic Grass,Artificial Golf Course,Artificial Grass
Changshu Keyuan Eco-friendly New Materials Co.,Ltd , https://www.ailiqingky.com