[ Chinese wardrobe net ] Three-door wardrobe is a kind of wardrobe that is more common in the market. Many families appreciate the three-door wardrobe. We all know that the size of the three-door wardrobe is relatively fixed. If you want to change the size of the three-door wardrobe, what should you pay attention to? Today, the Chinese wardrobe network summarizes the precautions for the assembly of the modern three-door wardrobe. You are helpful.
How much is the size of the three-door wardrobe?
The three-door wardrobe can be divided into a wardrobe with a sliding door and a wardrobe with a sliding door. The length of the three-door wardrobe of the swing door is 100cm-130cm, and the length of each door is between 30cm and 45cm. The door is too big or too The small is not good, the height is 80cm-180cm, too high, the strength of the door is not good enough. If it is a three-door sliding door wardrobe, the length is usually between 240cm and 360cm, and the size of each sliding door is 80cm-120cm. The sliding door is too small to look good, the sliding door will look drifting, and there is no feeling of strength. Enough, so when we are customizing the whole wardrobe , we should consider doing a few sliding doors.
The standard model size of the three-door wardrobe finished product on the market is 240cm×90cm, because the size of the wardrobe door is aesthetically pleasing, but if the size of the wardrobe door is 200cm×80cm, it is only a hundred. Ten blocks, but the effect is very general.
How to adjust the door of the three-door wardrobe
The installation adjustment of the three-door wardrobe door is very important and a technical activity. The usual adjustment method is to open the middle door and adjust the screws on the hinge with a suitable screwdriver. Note: the screws that are not fixed to the door and the cabinet are a screw on the hinge body near the door, fine-tuned clockwise. At this point, it is obvious that the door is moving in the middle. It is necessary to adjust all the hinges on the door, and then close it to see if it is adjusted or not. If not, repeat the above steps and adjust to the appropriate position. When you open the door on the right, repeat the above opposite action until it is appropriate, and pay attention to the size of the upper and lower sides of the adjusted door.
Assembly precautions for three-door wardrobe
1. Check the matching status of the drawing mark and the site carefully to determine the installation sequence.
2. Pay attention to the protection of the product assembly during the installation process.
3, the beam position, the top line, the cut-off angle of the closing plate should be carefully checked and the cutting is accurate.
4. Pay attention to the hole surface of the side panel of the cabinet as far as possible not to be placed in the cabinet.
5. When the nail backing plate is used, the diagonal of the measuring cabinet should be equal. If the solid layer is uneven, it should be flattened with a planing knife to nail the backing plate.
6. After installation, check whether the drawer is smooth and even, whether the gap is even; open and close the door, the installation is qualified, there should be no abnormal noise, the positioning is accurate, the gap on both sides is even; the horizontal plane of the wardrobe should be flat. All facades are vertical; drawers, sliding doors, etc. should be pushed and pulled smoothly, wherever the hand is pushed, where the door should stop.
Kindergarten Furniture,Kindergarten Plywood Chair,Kindergarten Chair For Kid,Kindergarten Plastic Chairs
AU-PINY FURNITURE CO., LTD , https://www.jmaupiny.com