[ Chinese wardrobe net ] First, the wardrobe common door failure and troubleshooting methods
1, the wardrobe sliding door can not move
1 Hanging rail and hanging wheel are not matched with optional goods; 2 hanging wheel bearing damage or outer layer damage replaces the upper part of the hanging wheel; 3 Nanjing wardrobe sliding door bottom touches the ground to adjust the height of the door; 4 bracket deformation causes the door to sag; replace the bracket.
2, heavy hand feeling, moving difficult
1 Hanging rail and hanging wheel are not matched with optional matching goods; 2 when the hanging rail device is deformed to replace the hanging rail; 3 hanging rail does not adjust the horizontal plane of the hanging rail from the head; 4 wardrobe sliding door under the ground, or locator and Nanjing wardrobe The sliding door is not on a vertical line, adjust the door height or move the positioner orientation; 5 the hanging wheel bearing has poor quality or no bearing at all, or the outer cladding is too soft to replace the hanging wheel;
3, there is a slamming or creaking sound
1 There is waste in the hanging rail to remove waste in the hanging rail; 2 the bearing itself has poor quality or there is waste in the bearing to replace the hanging wheel; 3 the bearing outer layer has dent, no lubrication or significant film line, burr replacement hanging wheel; 4 The suspension rail is not flat and has a burr to replace the hanging rail.
4, loud noise
1 The hanging rail is too thin, use thicker hanging rails, or hardwood on the two sides of the hanging rail; 2 lubricated, uneven, burred lubricated, flat hanging rails; 3 fixing screws are not tightened , or replace the longer screws; 4 fixed screws increase the fixed screws; 5 hanging rails and Nanjing wardrobe sliding door frame have gaps to make the hanging rails close to the door frame; 6 hanging wheel bearings themselves poor quality replacement; 7 hanging wheel outer layer Replace the hanging wheel with a round, dent, burr or film line.
Second, the wardrobe sliding door maintenance
In the long-term use of sliding door, due to the deposition of dust and dirt, especially when the air contains sulfide, it must be cleaned on time. The cycle is generally half a year. When cleaning, it is necessary to clean the surface dirt without damaging the surface oxide film. Electrophoresis composite membrane, spray powder.
1, sliding door cleaning
1 Regularly clean the surface of the sliding door with a soft cloth dampened with water or a neutral detergent. Do not use ordinary soap and washing powder, and do not use strong acid-base cleaners such as decontamination powder and toilet cleaner. 2 It is not allowed to use sandpaper, wire brush or other abrasives for cleaning. After cleaning, wash it with clean water, especially in places with cracks and dirt. Also use a soft cloth dampened with alcohol to scrub. 3 If the main material of the sliding door is made of sheet material, the moisture of the wet cloth used in cleaning should not be too much, as long as it is moisturized.
2. Track protection
Keep the track clean and prevent foreign matter from entering. If there are debris and dust, use a brush to clean it. The dust in the tank and the door can be sucked out by a vacuum cleaner.
3. Maintenance of internal accessories
Keeping the sliding door good performance The sliding door seems simple, but the structure and accessories are still more. The protection of the track and other aspects is very important. The sealing top and the glass seal are the key structures to ensure the sliding door sealing, heat preservation and sound insulation. If it falls off, it should be repaired and replaced in time, so as to achieve the best effect of dust, collision, sound insulation and heat preservation.
face cleaning spatula factory,ultrasonic skin scrubber wholesaler,ultrasonic skin scrubber manufacturer,facial dead skin peeling machine
Zhongshan Seven Cool Electronics Technology Co.,Ltd , https://www.gdsevencool.com