[ Chinese wardrobe net ] Solid wood wardrobe has always been loved by consumers because of its environmental protection and value preservation. However, the solid wood wardrobe is also expensive because of the irreplaceable production cycle and production process, and the high production cost. Some people may ask why the price of solid wood wardrobes is expensive. It is not known that the production process of solid wood wardrobes is extremely complicated, and the craftsmanship of workers is extremely high.
The process of solid wood wardrobe, in general, four steps: preparation → woodworking → painting → packaging, below we will understand what the specific content of these four steps.
First, the solid wood furniture process - preparation
1. Drying of the board:
The moisture content of the wood is controlled to 8%-10%, and the dried wood is not prone to burst deformation;
2, balance:
Placing the dried wood for a period of time to restore the balance of the wood;
3. Selection of ingredients:
The hidden parts of wood products can be divided into three types: exterior materials, crotch materials and dark materials. The exterior material is exposed to the outside, and the internal material is used inside the product, such as the inner and bottom plates. Dark materials refer to parts that are not visible under normal use, such as drawer rails, panel panels, and the like.
4, rough planing:
Thicken the wool board.
5, wind shear:
The length of the wool board is trimmed. The blanking is lengthened by 20 mm according to the required length.
6, trimming:
Cut off the edges that cannot be used on the wool board.
7, with the board:
The wood material selection board is divided into straight lines and mountain lines, and the colors are consistently matched. The width of the board is reasonable according to the required width. When selecting materials, remove the internal crack, end crack, thrift, blue, and dead wood.
8, cloth glue:
Evenly spread the glue between the woods, the ratio of the glue: the ratio of curing agent (10-15 grams) and jigsaw glue (100 grams), about 500 grams per time.
9, jigsaw:
Use the jigsaw machine to assemble the wood, and pay attention to the height difference, length difference, color difference, and thrift.
10. Chen Hua:
The wood finished with the glue is left for about 2 hours to allow the glue to solidify.
11, sand planing:
Remove the excess glue between the wood so that there is no excess glue on the wood surface.
12, sawing and width:
Use a single-piece saw to set the width of the wood.
13, four-sided planing:
Plan the wood according to the shape you need.
14, health:
Place the wood naturally for about 24 hours.
Bar Counter And Table,Bar Counter Table,Counter Height Chairs,Counter Height Bar Stools
Foshan Haoyu Furniture Factory , https://www.hyluxuryfurniture.com